Cutting Tool Coating Production
August 19, 2011 – 2:04 pm | No Comment

Click Image to Enlarge The CVD coating method (above) involves heating the substrates and exposing them to a gas stream. The gases break down on the hot substrate surface, where they form a layer. With all PVD methods, the laminate material is transported in a vacuum from a source via a transport space to the substrate.

Read the full story »
Heavy Industry and Manufacturing

Industrial Machine News

Machine Tool Builders

Manufacturing & Engineering

Technology News

Home » Featured, Manufacturing & Engineering, Technology News

Canadian lunar robot begins Earth-bound moon mission

Submitted by on August 31, 2011 – 12:18 pmNo Comment

Kamestastin Lake crater to play as lunar surface for University of Western Ontario robotic rover.

Share or bookmark this post:

The University of Western Ontario's lunar rover, ROC6, during a simulated lunar mission near Sudbury, Ontario in June. (Photo source: The Centre for Planetary Science and Exploration at the University of Western Ontario)

The University of Western Ontario’s lunar rover, ROC6, during a simulated lunar mission near Sudbury, Ontario in June. (Photo source: The Centre for Planetary Science and Exploration at the University of Western Ontario)

Since the end of the Apollo missions, space exploration has largely forgotten the Moon. Nearly four decades later, however, NASA and the Canadian Space Agency are taking another look at our nearest cosmic neighbour as a source of scientific discovery.

In support of that effort, a team of scientists and engineers led by Dr. Gordon Osinski from the University of Western Ontario travelled to an impact crater at Kamestastin Lake, Labrador, earlier this week, where they will run through simulated or “analogue” lunar missions with the team’s robotic rover, ROC6.

Over the next month, the team will conduct investigations in the area surrounding the lake to gain experience working with the robot. Two of the university crew will play “astronaut” during the exercise to work out how a combined human-robot team can more effectively gather relevant scientific data than either could achieve independently. Data will be relayed back to mission control, which is located at Western, throughout the mission.

“The Kamestastin Lake crater was chosen because it has a very similar geology to the Moon,” says Osinski. “Conducting analogue missions like this one allows scientists to determine not only what kind of samples they would encounter on the Moon, but which instruments are best suited to help them determine the samples that should be returned to Earth for further analysis.”

This analogue mission is the third of three missions planned under this contract financed by the Canadian Space Agency for the investigation of the formation processes and resource potential of impact craters. This project is completed by Western with its Kamestastin Research Analogue Site for Human exploration (KRASH) mission partners: the University of Toronto’s Institute for Aerospace Studies (UTIAS), Memorial University of Newfoundland, York University, the University of Manitoba, Washington University in St. Louis, and the University of Arizona. Industrial partners include, MacDonald, Dettwiler, and Associates (MDA), Optech, and Sensors and Software.

The Centre for Planetary Science and Exploration (CPSX) represents the largest concentration of planetary scientists in Canada and has resulted in Western becoming the epicentre for planetary science and exploration in the country – particularly for graduate students.
http://cpsx.uwo.ca

Read the original here:
Canadian lunar robot begins Earth-bound moon mission

Leave a comment!

Add your comment below, or trackback from your own site. You can also subscribe to these comments via RSS.

Be nice. Keep it clean. Stay on topic. No spam.

You can use these tags:
<a href="" title=""> <abbr title=""> <acronym title=""> <b> <blockquote cite=""> <cite> <code> <del datetime=""> <em> <i> <q cite=""> <strike> <strong>

This is a Gravatar-enabled weblog. To get your own globally-recognized-avatar, please register at Gravatar blog.